Led profile corner 2323 3m linear lux delivers precise accent lighting for modern coves and architectural edges. This slim linear solution fits 23 mm profiles and provides uniform brightness across three meters while staying energy efficient.
Designers choose these modules for seamless integration into suspended ceilings, retail plinths, and gallery tracks. The compact corner modules enable clean transitions at intersections without visible wiring clutter.
| Model | Reference | Key Specs | Typical Use |
|---|---|---|---|
| Profile Corner Module | LP-2323-CL | 23x23 mm profile, 3 m length | Cove, recessed accent, display lighting |
| Driver Compatibility | SE-35-45W | 35 W, 24–48 V, DALI dimming | Controls brightness and scenes |
| Optical Output | 3000 lm, 3000 K warm | Uniform lux distribution, CRI>80 | Retail, hospitality, museum |
| Installation Type | Low-voltage plug-in | Cut-to-length, clip-in terminals | Fast retrofit into aluminum profiles |
精准光学与安装特性
Linear modules for 23 mm profiles maintain consistent lux levels across the full 3 m run. Integrated diffusion ensures soft transitions at corners and minimal hot spots.
Corner brackets allow 90° turns while preserving optical alignment. This makes layout planning straightforward for complex ceiling grids and showcase perimeters.
电力与调光灵活性
Low-voltage 24–48 V operation reduces installation risk and enables dimming for mood settings. The modules work with 0–10 V, DALI, and PWM controllers for layered lighting designs.
Each segment draws approximately 1.2 A at full white, so a 35 W driver can manage up to two 3 m linear sections with margin for startup surge.
材料与防护等级
Die-c aluminum profiles and PC lenses provide thermal stability and impact resistance. Surface treatments resist yellowing under office and retail lighting conditions.
IP20 front protection blocks accidental contact while allowing close mounting to translucent panels. For high humidity zones, choose versions with silicone-sealed joints.
规划与布线策略
Measure run lengths and subtract corner module depth to avoid overcutting. Plan power injection every 2–3 m to maintain luminance consistency across long spans.
Use centralized bus bars for multi-zone projects to simplify commissioning and future maintenance. Label each connector to match D群组 scenes and simplify troubleshooting.
高效部署建议
- 核对型材尺寸与模块厚度，确保23 mm卡槽兼容
- 计算总功耗并选择匹配的35 W或更高功率驱动器
- 规划电源位置以缩短直流配线并减少压降
- 测试全亮与调光场景，确认色温和亮度符合设计意图
- 记录通道地址与回路图，便于后期维护与改造
FAQ
Reader questions
能否将这款2323角部模块直接用于户外？
不建议直接用于户外，建议选择IP65或更高防护等级的外置电源和密封模块以应对风雨和湿气。
3米长度的实际均匀度如何？
在适当功率注入和散热条件下，3米范围内照度偏差可控制在±5%，配合扩散罩能进一步减少可见热点。
角部模块是否需要特殊工具安装？
标准角部模块采用卡扣设计，配合一字螺丝刀即可完成安装与固定，通常无需额外专业工具。
DALI调光会不会影响光源寿命？
规范使用DALI调光并保持在合理亮度范围内，不仅不会显著缩短寿命，还能通过降低工作温度延长LED使用时间。