Removing the bumpers on the Mitsubishi L200 Triton V 2015 2023 helps with access, cleaning, or minor repairs. This guide walks through the process safely for both short term and long term maintenance.
Before starting any bumper work, plan the steps, gather tools, and confirm vehicle specific guidance for your exact model year.
| Model Year | Bumper Type | Primary Fasteners | Typical Tools Required |
|---|---|---|---|
| 2015 2017 | Plastic front and rear | Clips, 10 mm bolts | Socket set, Torx bits |
| 2018 2020 | Reinforced plastic with metal inserts | Clips, 12 mm bolts, hidden screws | Socket set, Torx bits, Trim tools |
| 2021 2023 | Updated design, larger sensors | Clips, 10 mm and 12 mm bolts, wiring harness mounts | Socket set, Torx bits, Trim tools, Basic wiring knowledge |
Preparing For Bumper Removal
Proper preparation reduces the risk of scratches, broken clips, or damaged sensors. Work on a flat surface and disconnect the battery when necessary.
Tools And Safety Precautions
Gather a socket set, Torx bits, flat trim tools, screwdrivers, and wiring harness disconnectors. Wear gloves to protect painted surfaces and use wheel chocks to keep the truck secure.
Removing The Front Bumper
The front bumper on the Mitsubishi L200 Triton V 2015 2023 attaches with clips and bolts around the valance and corners. Approach this task methodically to avoid stressing sensors or wiring.
Step By Step Front Bumper Process
Open the hood, remove the grille if obstructed, unclip the top edge, disconnect any front sensors or cameras, then carefully lower the bumper after removing the main bolts.
Removing The Rear Bumper
The rear bumper follows a similar pattern but often hides fixtures for number plate wiring and reversing sensors. Access is usually better from inside the tailgate area.
Step By Step Rear Bumper Process
Support the bumper from inside, remove interior panels if needed, unclip the lower edge, disconnect wiring, and gently pull the bumper away while supporting its weight to prevent cable damage.
Inspection And Preparation For Reinstallation
Once removed, inspect the bumper and mounting points for cracks, rust, or worn clips. Cleaning and addressing small repairs now makes reinstallation smoother and ensures a secure fit.
Checklist Before Refitting
Verify all wiring connectors are undamaged, drainage holes are clear, mounting clips are replaced if needed, and the bumper surface is free from debris that could affect sealing.
Key Takeaways For Mitsubishi L200 Triton V 2015 2023 Bumper Removal
- Always disconnect the battery when working near electronics.
- Use the correct socket and Torx sizes to avoid rounding bolt heads.
- Support the bumper weight while unclipping to protect wiring and sensors.
- Inspect clips and sealing surfaces before reinstallation.
- Label wiring connectors and take photos during disassembly for easier reassembly.
FAQ
Reader questions
Do I need to disconnect the battery before removing the bumpers?
Yes, disconnecting the battery is recommended when working near sensors, cameras, or wiring to prevent accidental shorts and ensure safety.
How many clips typically hold the Mitsubishi L200 Triton V 2015 2023 bumpers in place?
Expect around 8 to 12 clips per bumper, plus a few visible bolts, depending on the model year and bumper style.
Can I remove only one side of the bumper for repairs?
Yes, you can remove one side if the work is localized, but support the bumper carefully to avoid stressing the opposite clips or wiring.
What should I do if a clip breaks during removal?
Replace the broken clip with a genuine or high quality aftermarket part and reinstall using the original positions to maintain alignment and sealing.